Saturday, 20 March 2021

15mm 3d Printed models - Battlefield3D

Hi folks,

Slow progress - relatively - on the hobby front. I've finished another troop of Cromwells and started on the last three vehicles. More on them in a bit.  

In the last few weeks I've picked up a couple of unusual models, initially from an Ebay seller but more recently from his shop Battlefield3D. A few other hobby blogs and sites have shown off some of the prints, but I'd asked for a few specifics from his catalogue which I don't think will have been seen elsewhere. I had a chance today to get out with the spray can, so the models have had a base coat applied. 

First up, I've had a bit of a plan to do some of the softskin vehicles which might have supported my 144RAC tank squadron. Namely, a small replenishment convoy in the form of a truck for munitions, a petrol tanker and a water tanker. 

CMP 60L Petrol Tanker


CMP 60L Water Tanker


CMP F60 GS Lorry



All three of the 'A' Echelon vehicles. 

Next up, some vehicles I had wanted for a little REME diorama to go with my earlier Light Breakdown Truck

Austin K6 Gantry Lorry (tow position)



 To go along with this, I picked up a little Austin Tilly utility van, and a staff car. 



As I also have plans to do some sort of infantry battalion HQ diorama (probably along with the staff car above, maybe with a jeep), I also picked up a couple of radio trucks. I've cut off the radio aerial base in order to drill out the hole for my usual fishing line aerial. 

Fordson WOT2D Radio Truck


Bedford MWR Radio Truck


I also picked up a cool little model to go with one of my Sexton batteries:



Hopefully you can see from the pictures that the details on these models are superb. The resin is nice and clean with the print lines barely visible. Details such as grab rails are lovely and sharp. The resin is very brittle, however, so care should be taken if you are trimming or cutting. In fact, I would avoid cutting where you can, my attempts at putting the winch on the gantry lorry were frustrating and upsetting as the section I was trying to cut shattered several times. 

Scale wise, the models fit in well with the rest of my Battlefront resin vehicles:






These models did cost a little more than you would expect for 3D prints, but the quality really is amazing and the customer service has been great. There is also a good range of options to pick from, as can be seen in the catalogue. My models all came from the Marco Bergman collection, which Battlefield3d have a commercial license for. 

These vehicles have all been added to the paint queue - hopefully it won't be too long before I can get them done. 

2 comments:

  1. Really nice additions Jamie. Liking how they are not the usual type of vehicles in one's collections; I might have to find similar for my Soviets.

    ReplyDelete
    Replies
    1. Cheers Dai - table dressing mainly, but I enjoy adding some of the more unusual bits. Nice to have them available at such good quality.

      Delete

If you follow my blog, please feel free to leave a comment - it will appear once moderated!